Featured Artist Customer Kim

Kim showed us this darling little Toilet Paper Roll Gift Card Holder and even sent me the instructions.  She wanted me to say she found this online – thank  you for sharing Kim

 
Here are instructions for this cute project

Cut 3 pieces of Designer Series Paper 6" x 4 1/2"

One Piece Cut 2 1/4" x 2 5/8" (for the bottom)

For the tags cut 3 piecs 4" X 2 7/16" and 3 pieces 3 1/4"

Punch out three pieces of Card Stock using the Round Tab Punch (119864, page 202).  Use the Corner Round punch (119871, page 200) to corner the tags.

Cover Toilet Paper Rolls, then at the bottom, use sticky tape to attach the three together.

Round the corners of the small piece of card stock.  Fold in half and attach over the 3 covered Toilet Paper Rolls.  Use the large hold on the Crop-A-Dial (108362, page 198) to punch through the three toilet paper rolls and tie with ribbon to finish.

Assemble tags; cut slits to hold gift cards and use one tag for sentiment.

Please email me if you have any questions and I will ask Kim :) 

Thanks again for sharing this wonderful project Kim

To place your order for Stampin' Up Supplies online 24/7 click here